In Phase IPA9704D 2Ω Stable 1600 Watts Digital 4 Channel Amplifier

Car amplifiers are the heart of a system and need be of the best quality available for your budget. All In Phase IPA car amplifiers are hand assembled and go through 35 different check points to ensure you get the best possible car amplifier today.

With One and Two OHM stable designs, trimode capability and clever protection circuits, these hand-built powerhouses will take anything you throw at them. Massive heat sinks with a high surface area to volume ratios and cast end caps to hide the wiring connections and keep things controlled – helped by forced air cooling on the real bass monsters.

The newly designed IPA8701D, IPA8704D, IPA9701D and IPA9704D now incorporate digital technology into their design, these amps are direct competition to the Pioneer GM-D amplifiers.

The IPA series amplifiers are designed for performance in a performance build. So there is no speaker level input, these are designed to fit with an aftermarket headunit. But you do not need to panic, you can use a line out converter to fit this amplifier to your factory system. For fitting the IPA series amp to a factory system we advise using the In Phase SRCAPro or for higher performance, the In Phase SRC6.

In Phase IPA 9704D
Power source 14.4V DC (10V to 16V)
Grounding system Negative type
Current consumption 39A (at continuous power : 4Ω)
Average current consumption 1.4A (4Ω for four channel)
1.6A (4Ω for two channel. BRIDGES)
1.7A (2Ω for FOUR channel.)
Fuse 40A x 2
Dimensions (W x H x D) 250mm x 55.5mm x 340mm
Weight 3.2kg (7lbs excluding cables)
Maximum power output 260W x 4 (4Ω)
400W x 4 (2Ω)
800W x 2 (4Ω)
1600W Total Power
Continuous power output 130W x 4 (at 14.4V. 4Ω 20Hz to 20kHz.<1% THD)
200W x 4 (at 14.4V. 2Ω 20Hz to 20kHz.<1% THD)
400W x 2 (at 14.4V. 4Ω BRIDGE. 20Hz to 20kHz.<1% THD)
Load impedance >4Ω (2Ω to 8Ω allowable
Frequency response 10Hz to 50kHz (+0dB.-3dB
Signal noise ratio 95dB (IHF-A network
Low pass filter:
cut off frequency 50Hz to 250Hz
cut off slope -12dB/oct
High pass filter
cut off frequency 50Hz to 1.2kHz
cut off slope -12dB/oct
Bass control:
Frequency 50Hz
Level 0dB to 12dB
Gain control 200mV to 6V
Maximum input level / impedance 6V / 22kΩ
Power output 130W RMS x 4 Channel (at 14.4V 4Ω 1 kHz and <1% THD+N)
400W RMS x 2 Channel (at 14.4V 4Ω BRIDGE 1 kHz and <1% THD+N)
200W RMS x 4 Channel (at 14.4V 2Ω 1 kHz and <1% THD+N)
S/N ratio 75dBA (refrence : 1W into 4Ω)